Ice Fishing

K-Drill Ice Auger a product of A.W.C. Distributing, Inc. conveniently located at 6667 W. Old Shakopee Road, Suite 102, A.W.C. Distributing, Inc. has been an integral part of the Minneapolis/Saint Paul community with a rich history and an exciting future.  A.W.C. Distributing, Inc. gained the reputation for outstanding service and commitment to customer satisfaction in the greater Twin Cities area for it's Marine Electronic and ice fishing gear. 

The goal is to make sure our ice auger is light weight and efficient for those fishermen who love to ice fish.  We want to make sure you 

optimize your fishing time while minimizing time spent drilling holes looking for fish.  Fast – Lightweight – Efficient – K DRILL!  The K-Drill Ice auger System is one of the most valuable assets you have to enjoy ice fishing on the go.

FREE Life Time Blades Sharpening Commitment

Get in Touch

Contact us at 952-224-3649 to get your K-Drill Ice Auger System Today!

Blade sharpening for the K-Drill is FREE unless the blades have been abused drilling into rock, gravel, sand, etc, READ the warranty policy on the back of your manual. The blades can be re-sharpened 2-3 times under normal use, before needing replacement. After re-sharpening blades multiple times they may fall outside the specification where they can safely be re-sharpened. It will then be necessary to purchase a new replacement set of blades for your K-Drill. Please let us know if you would like to purchase an additional set of blades when you return your blades for re-sharpening. We will notify you at the time of re-sharpening whether your blades cannot be re-sharpened due to wear or neglect.

•     CAUTION – Blades are sharp! Use leather gloves when handling blades. 

•     Remove the center tip blade with 3/16” Allen wrench.

•     Remove outside chipper blades with 7/16” open end wrench.

•     Replace outside chipper blades – snug bolts into position then torque an additional ¼ turn and STOP! (If possible torque to 115 in/lbs) DO NOT OVER TIGHTEN as it will strip the threads and this will not be covered under warranty.

•     Replace center tip – adjust the blade so it is equally spaced side to side from the chipper blades installed in the previous step. NOTE: the center point of this blade is designed NOT to be centered in the opening – gauge the edges from the chipper blades. Torque bolt of center tip to 115 in/lbs.

•     To prevent rust - K-Drill blades are made from tool steel and will require having a coating of grease or oil when being put away for storage for the year.


When returning a set of blades for re-sharpening please wrap them and return them to the address shown below:

          AWC Distributing/Blade Re-sharpening

          6667 West Old Shakopee Rd. Suite 102

          Minneapolis, MN 55438

Be certain to include your name-address and phone number along with your returned blades.

The Future of....

Ice Fishing!